LG HDPE料 SM800 TDS

Test Method Unit Value Physical (1)

Density

ASTM D792 g/㎤ 0.955 MFR(190℃,2.16Kg) ASTM D1238 g/10min 8.0 Softening Point (Vicat) ASTM D1525

℃ 124 Mechanical (2)

Tensile Strength at Yield point ASTM D638(3) kg/㎠ 270 Elongation at Break

ASTM D638(3) % >500 Shore hardness(Shore D) ASTM D2240 - 65 Flexural Modulus1% Secant

ASTM D790 kg/㎠ 10,500 Charpy Impact Strength at 23℃ (notched) ISO 179

KJ/m 2

4.0 Thermal

Melting Temperature

LG

℃

132

Description

• Cap & Closure for beverage bottles of still mineral water and juice • Cartridge &Pail

Applications

(1) The properties data in this table are typical values, and not guaranteed specification.

(2) Typical resin property values are measured on a standard compression molded specimens (3) Speed of 50 mm/min

Typical properties

Processing information

•LUCENE SM800 is qualified to be processed with the standard injection machinery.

•It is recommended to keep the operational temperature below 250 ℃ to prevent decomposition of the material.

Head office PO Division, LG Chem Ltd.

Yeoui-do P.O.Box 672, 21st floor LG Twin Tower, Yeoui-daero 128, Yeongdeungpo-gu Seoul, Korea. Tel. 82-2-3773-3538

TS&D

Tech Center

175, Gajeong-ro,Yuseong-gu, Daejeon, 305-343, Korea.

Tel. 82-42-860-8341

For additional sales, order and technical assistance

Revised : 25/03/2016

• LUCENE SM800 is mainly intended for injection molding. • It gives excellent processing performance • Without slip agent

LUCENE TM

SM800

High Density Polyethylene

- Copyright 2016. LG Chem, Ltd. all rights reserved.

The information contained herein, including, but not limited to, data, statements and typical values, are given in good faith. LG Chem makes no warranty or guarantee, expressed or implied, (i) that the result described herein will be obtained under end - use conditions, or (ii) as to the effectiveness or safety of any design incorporating LG Chem materials, products, recommendations or advice. Further, any information contained herein shall not be construed as a part of legally binding offer. Especially, the typical values should be regarded as reference values only and not as binding minimum values. Each user bear full responsibility for making its own determination as to the suitability of LG Chem's materials, products, recommendations, or advice for its own particular use. Each user must identify and perform all tests and analyses necessary to assure that its finished parts incorporating LG Chem material or products will be safe and suitable for use under end - use conditions. The data contained herein can be changed without notice as a result of the quality improvement of the products."